|
EASY TO USE
The Kenlowe pre-heating system incorporates a specially made plug
that can be mounted above or below the bumper where it will be convenient
for use without even needing to lift the bonnet. Simply plug in
to the special socket provided for your extension lead and connect
to standard mains 13amp* wall socket. The appliance may be switched
on around 20* minutes before your expected departure, or alternatively,
use a mains domestic appliance timer programmed for your regular
requirements. To heat the interior and demist the windows turn the
vehicle interior fan on as soon as you start your vehicle. Optional
auto interior sensors can be specified that allow you to pre-heat
the passenger compartment whilst the engine pre-heat cycle is taking
place. (See separate section).
*A 20 min. engine
pre-heating running cycle is typical for a 2.0 litre engine-smaller
or larger engines decrease or increase this time.
*9amp 2000-watt
model available if needed if you're A.C. mains supply is limited.
In line with
E.E.C. law we recommend you use an E.C.L.B. (earth leakage circuit
breaker) with any A.C. appliance used outside.
Running Kenlowe
Hotstart costs around 10 pence to pre-heat a typical family car
assuming an ambient of 0°C.
|
